Avery ALS 256 - Manual (Page 32)

28
C
ONTENTS
2.4 F
UNCTION DESCRIPTIONS
ALS
20x
256
GB
2.4.5 SERVICE DATA menu
If the displayed text is longer than the line
length of the display:
£ Press the button to move the text to the
left.
£ Press the button to move the text to the
right.
> MODULE FW VERS. submenu
System version function:
– Shows the firmware version of the labeller
> OPERATIONAL DATA submenu
Service operations function:
– Displays the number of service operations that have
been implemented.
– Increment the counter using the
SERVICE/DIAGNOS. > Service function.
– Maximum number: four billion
Material feed function:
– Displays the entire material feed, in other words, the
‘distance covered’ by the drive roller.
– Maximum number: four billion metres
Dispensing cycl. function:
– Counts the number of dispensed labels.
Operation time function:
– Displays the entire on-time
>POWER SUPPLY DATA submenu
Type function:
– Displays the type of power supply
> CPU BOARD DATA submenu
CPU identifier function:
– Displays the identification of the processor in use.
PCB Revision function:
– Displays the layout revision and the part number of
the CPU board.
FPGA version function:
– Displays the FPGA version.
MAC Address function:
– Displays the MAC address, which is a fixed and
unique board address for the Ethernet interface and
is programmed by the manufacturer of the board.
Serial number function:
– Displays the serial number that is programmed by
the board manufacturer.
Production date function:
– Displays the production date of the CPU board
PCB part number function:
– Displays the part number of the unpopulated board.
Board part numb. function:
– Displays the part number of the populated board
> DISPLAY DATA submenu
Remote Disp.vers function:
– Displays the version of the external operator panel
> CF CARD SLOT submenu
Card in slot function:
– Tests whether the CF card is inserted in the device’s
card slot.
– If the result is ‘Yes’, then the CF card is in the slot.
– If the result is ‘No’, then there is no CF card in the
slot.
> PERIPHERAL DATA submenu
Applicator int. function:
– The function is only available when an applicator
interface is integrated.
– Displays the firmware version of the applicator
interface.
>MEMORY DATA submenu
Ram memory size function:
– Displays the amount of RAM available.
Flash mem size function:
– Displays the amount of Flash memory available.
Default values function:
– Values that are used for a factory reset (standard or
‘User defined’, s ee MACHINE SETUP > Default values ).