Power Probe The Hook - Manual (Page 5)

Page 5
The Five Button Switch performs many different functions
depending on the state of which the PPH is in at the time. To
standardize our terminology when referring to the individual
buttons of the Five Button Switch, we will use the following
identifiers: U, D, L, R, and SEL.
See the terms and definitions below:
U = (+) = UP BUTTON or TOP BUTTON
D = (–) = DOWN BUTTON or BOTTOM BUTTON
L = (Speaker symbol) or LEFT BUTTON
R = (Hot Shot symbol) or RIGHT BUTTON
SEL = SELECT BUTTON or CENTER BUTTON
AC Threshold
Setting in V
olts
Speaker On/Of
f
Circuit Breaker
Setting
in Amps
Power Switch Settings
DC V
oltage
Drop Setting
5 2 0 M 5 0
1 A T T B 0 2
II - FIVE BUttON OpErAtIONAL tErMS
On
Off
5 2 0 M 5 0
1 A T T B 0 2
5 2 0 M 0
1 A T T B 0 2
5
Press to toggle
On or Off
D
U
R L
III - prEFErENCES AND SEttINGS
a) preference Line (top row)
In Power Probe Hook Mode (PPHM) with the probe tip floating
or unloaded, the top line of the display shows the present op-
erating parameters of the PPH. You will want to become very
familiar with the preference line of the PPH so you will know
exactly how it will operate at any given time.
b) Speaker ON/OFF
To toggle the speaker ON or OFF in PPHM:
1. Press L (Speaker symbol)
2. Notice the speaker symbol in far left of the preference line
when the speaker is visible in the Display. This means the
Polarity Tone is ON.
c) Circuit Breaker preferences
To adjust and set the Circuit Breaker Preferences
while in PPHM:
1. Press SEL once. Display shows CIR BREAKR.
2. Press L or R to the desired trip point: 2A, 5A, 10A, 15A,
20A, 25A, 30A, 40A, 50A, or 65A.
3. Press SEL to return to PPHM.
4. Notice the new Circuit Breaker Setting in the
preference line.
K A C R B R E R
5 A 6
I
SEL
Preference Line