Poweramp POWERSTOP A 11.1996 - Manual (Page 13)

INSTALLATION OF SIGN
Because of the many ways signs can be mounted, hardware is not supplied. Mount
the sign(s) on the right hand side, as viewed by truck driver, of restraint. The signs
are usually mounted near the outside signal light permitting the truck driver to read
signs from the truck.
Figure 11 provides a suggested location for mounting the signs. Good workmanship
and quality materials should be used.
NOTES:
1. Some docks may have dock/truck seals (or shelters) installed or planned. Sign
location and mounting should be studied before proceeding.
2. If required, signs may be trimmed for fit. NEVER cut or eliminate sign letters/
words.
Figure 16
Conduit, flexible or rigid, must be connected between the
limit switch on the restraint and the powerpack. Wiring to
and from the restraint must be limited to restraint wires
only. Do not run high voltage lines through the same
conduit as restraint wires. Conduit and associated
hardware to complete wiring and mounting of powerpack
are to be supplied by others. If the powerpack will be
mounted next to the truck restraint. Figure 15 illustrates
the approximate location of the powerpack mounting
bolts. When the powerpack is to be located inside the
building on a building wall an alternative to core drilling
into the pit would be to drill through the building wall as
shown in Figure 16. When this installation method is
selected the conduit for the Dock Alert II lights can pass
through the same wall opening. Hydraulic lines and
conduit must be fastened to the building to prevent
damage.
10
Installation
17”
8”
10”