Poweramp SEMI AUTO TRUCK RESTRAINT 11_96 - Manual (Page 8)

Installation
6
Figure 10
Using the proper diameter bit, drill a hole into the
base material to a depth of at least 1/2" or one
anchor diameter deeper than the embedment
required. The tolerances of the drill bit used
should meet ANSI Standard B94.12.
Blow the hole clean of dust and other material.
Remove the inspection tag from the anchor and
position the fixture. Do not expand the anchor
prior to installation.
Drive the anchor through the fixture into the
anchor hole until the bolt head is firmly seated
against the fixuture. Be sure the anchor is driven
to the required embedment depth.
Tighten the anchor by turning the head 3 to 4
turns.
Figure 9