PROLiNK WG3000 Wireless LAN Card 802.11g - Manual (Page 24)

- 20 -
BSSID the BSSID of the Access Point to which the
card is associated
Connect Highlight one of the device from the list area
and press the Connect button to access it.
Modify There will be three tabs for you to modify, see
the detailed information on page 21.
Rescan Searches for all available networks. Clicking
on the button, the device will start to rescan
and list all available sites.
Preferred SSID Type in the SSID name of the device you want to
connect.
BSS Type You can select Peer-to-Peer, Access Point or Auto
Mode of the device you to connect.
Tx Rate You can select the data rate or set to auto mode from the
pull-down menu.
Channel Select the channel depends on your country.
Power Mode No Power Save：Select this function , the adapter will be
in full active mode.
Max Power Save：Select this function, the power save
mode will be enabled.
4x Config Select to disable or enable the TI-Based 4x function.
Packet Burst Enable Enable this function（if the device you connect
supports Packet Bursting Mode） to increase the
efficiency of your network.