PSA LIFCO9 - Manual (Page 12)

Mounting
This CO alarm can be either wall mounted
or placed on a tabletop.
For wall mounting, follow these steps:
1. Mark the location of the two holes
needed on the wall using the battery
door as a template. Placing at eye level
allows for optimum monitoring of the
red and green indicator lights, or,
as a guide, 1.5 metres from the floor.
2. Insert the two screws provided until the screw heads are protruding
approximately 1/8” from the wall.
(If mounting in a plasterboard or
drywall, drill a 3/16” hole in the
wall and use the plastic anchors
provided.)
3. Hook the CO alarm over the
screws and onto the keyholes in
the back of the alarm.
Your CO alarm may also be placed on
a tabletop. Simply place in a location
that is easily visible. Be sure the alarm
is no more than 1 metre from the floor.
Important Labels Provided
Two labels have been provided that have important information on what to
do in case of an alarm. Place one label next to the alarm after it is mounted,
and one label near a fresh air source such as a door or window.
4. Installation Instructions
Wall Mount
Screw Head Distance
from Wall
2522-7216-00 (900-0233):_ 2011.10.21 5:10 PM Page 12