PSA PANQ916K, Q916K/SP - Manual (Page 4)

4
 Use 6 core cable (14/020) or CAT5 cable between all stations.
 Figure 8 cable is required between the Door Station and electric door
latch.
 12V DC auxiliary output provided on the master station when door bell
is pressed. Figure 8 cable is required from Master station to auxiliary
device.
 Wire each station according to the wiring diagram; follow the colour
codes on each terminal carefully.
 Power supply plug pack should be installed as close as possible to the
Master Station in a ventilated and accessible area, for example, in a
cupboard, pantry or wardrobe. The plug pack should never be located
in the roof or under the house.
 It is preferred that all system wiring runs back to the Master Station –
“Star Configuration”. If this is not practical, cables can be looped via
Room Stations back to the Master Station.
 All wiring should be kept as short as possible. Exceeding 200m of total
wiring may degrade communication quality.
Caution: To avoid electrical interference, be careful not to run
intercom cables near mains cable or through the same ducting or
conduits as mains cable.
Caution: To avoid audio feedback, units should be installed at least 5
metres apart, not in the same room or back to back on a common wall.
Do not install near light dimmers, fan controllers or other radio
interference sources.
If wiring with Category 5 cable, please ensure the twisted pair cables are wired according to
the table below:
System Terminals Cat 5 cable
+24Vdc (Blue) Blue
Data (Green) Green
Ground (Yellow) Orange
Green/White
Audio + (Red) Brown
Audio – (Black) Brown/White
Latch – (White) Blue/White
Orange/White
Music/Auxiliary
Terminals
Cat 5 cable
Ground (1) Green/White
Blue/White
RLY relay (2)
+12V (3) Blue
MUA (4) Brown
MUB (5) Brown/White
DET (6) Green