Elite Screens Evanesce Series - Manual (Page 2)

2
Accessories for Evanesce Series
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures.
 Reorient or relocate the receiving antenna of the device which may be causing interference
 Increase the separation between the screen and the device’s receiver
 Connect the equipment into a different power outlet than the device’s
 Consult the dealer or an experienced Radio/TV technician for help
Pre-Installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign particles
such as dust, sawdust, and/or liquids.
NOTE
Regardless of the mounting method, the screen should be securely supported so that the vibration or pulling on
the viewing surface will not cause the casing to become loose or fall. The installer must insure the fasteners that
are used are of adequate strength and suitable for the installation location.
Red 1 2V (+) Green 0V (-)
E. 5-12 volt trigger
adaptor cable
G. AAA Ba t t er i e s
A. IR Remote B. RF Remote C. 3-way switch
F. Bubble level
D. I R ” eye”
recei ver