Elite Screens Evanesce Plus Series - Manual (Page 4)

Rev.040313-JA www.elitescreens.com 4
Hardware Parts List for Evanesce Plus Series
Please make sure all parts listed below are included before proceeding with the installation.
A. Hexagonal nut x 4 B. M6x13 hex screw x 8 C. Hanging bracket x 2 D. Washer x 12
E. Turnbuckle x 4 F. Suspension Bar x 4 G. M6 nut x 4 H. End cover flange panel
Power
The Evanesce Plus Series includes a 3-Prong Power Cord for use in a non-concealed power outlet. If your
installation will be entirely concealed (including the power outlet), Elite Screens strongly recommends a
hardwire connection. Please refer to the image below for both 110v & 220v wiring information.
Assembly
1. Insert the M6x13 hex screw (B) through the Hanging Bracket’s (C) screw hole and secure with
the Hexagonal nut (A). Slide the Hanging Bracket (C) through the railing on top of the case.
Repeat the same for the other side.