Attaching the screen once it is unpacked – Elite Screens QuickStand Series User Manual
Page 8
Rev043010-JA
www.elitescreens.com
2. Make sure that the first folds never exceed 3 feet in width (fold again if necessary). Also make sure
that there is always clean packing paper in between the two surfaces.
3. Larger sized screens will need to be folded with more frequency than smaller screens. Follow the
instructions from step 1 as well.
4. Fold the material from top to bottom first then alternate in folding left to right until the material is of a
sufficient size that will fit into the leatherette case.
Note: Keep the screen material inside its case when not
in use. Failure to follow this precaution may eventually
result in staining or discoloration.
Cleaning
The screen surface can be cleaned as follows.
Use a clean white cloth (100% cotton preferred) and dampen it with clear water. Gently wipe in one direction
and NOT in a circular motion. Use another dry cloth to dry after each cleaning session. To remove a
stubborn stain or sticky surface, use denatured alcohol (methanol or methyl alcohol) in lieu of water.
Attaching the Screen once it is unpacked
1. Using the snap buttons to connect the Screen material with the case
2. Start at the top working in whatever direction is most comfortable to you
3. Stretch the corners if necessary to pair up the buttons with their corresponding snaps