Elite Screens ezCinema Series - Manual (Page 3)

Rev101912-JA www.elitescreens.com 3
Setting up the screen
Installation:
The ezCinema screen is designed to be used as an easy to operate portable screen for a variety of
presentation environments. Its design enables it to be versatile for use in either classroom,
conference room, home or patio presentations. When packed, the unit carries with ease and opens up
for projection presentations within seconds. As a general rule, portable projector screens should be
installed in an area free from wind and heat or open flame sources such as a heater, BBQ grill or
fireworks display.
Extend the base feet:
For sizes below 100”
Locate the base feet on the bottom of the box cover at each end and rotate the base foot until it forms
a right angle between the footboard and the cover box.
For sizes 100” – 150”
All models including 100” utilize the short and long feet cups. Locate each screw hole on the bottom
of the case of the screen and screw in a short foot cup on the base feet and the long foot cup on the
ends. Short cups included only in the 135” and 150” models.
Open the box cover:
Unlatch the buckles on both ends of the box and open the box cover. Next, secure the box with one
hand while removing the telescopic support rod with your other hand.
Long foot cup
Short cup