FEC AFC1500 User Manual
Page 46
Chapter 4: System Setup and Wiring
Page 4-2
4.1
Design and Build Procedure
Review Chapters 1 and 2 prior to designing a System. If the requirements and specifica-
tions in these two (2) Chapters are not addressed, there is a chance of degraded System per-
formance.
WARNING:
Follow Lockout/Tagout and other safety precautions when connecting and/or
disconnecting cabling, wiring, and equipment.
No.
Items
Comments
Reference
Section
1
Select correct tool size.
Keep torque range between 50% and 75 % of tool
capability for best performance.
Ensure fastening bolt pattern and tool mounting
patterns are compatible.
2.4.1
4.4.1
4.4.2
2
Design tool mounting
plate, powerhead and
spindle assemblies.
Design of mounting plate / powerhead requires
adherence to several specifications.
4.4
4.4.3
3
Select correct San Unit for
the tool selected.
Different tool motors require different Servo Ampli-
fiers. Ensure the correct one is selected.
2.4.1
4
Select the circuit protec-
tors.
Circuit protection for San Units should be separate
from other units.
4.5
4.6
5
Select an air handling unit
(as required).
Select an air handling unit applicable to the envi-
ronmental conditions (A/C, Heat Exch., etc.)
2.1
6
Select an adequate PLC.
Select a PLC which will facilitate direct connection
to the AFC1500 System I/O (24 VDC true low).
4.7
7
Design (or review) PLC
logic.
A PLC logic program can be written using signal
descriptions and timing charts provided.
4.7
8
Select NEMA 12 enclo-
sure.
Keep clearances among units according to the
recommended installation layout.
4.2
4.3
9
Set San Unit dip switches. Check the setting before connecting the Unit.
4.10
10
Mount the San Units in the
enclosure.
Refer to recommended installation layout.
4.2
4.3
11
Wire power connections.
Connect the power cables. VERIFY VOLTAGE
PRIOR TO APPLYING POWER.
4.6
12
Wire I/O connections.
Connect all I/O wiring. VERIFY VOLTAGE
SOURCE PRIOR TO CONNECTION.
4.7
13
Connect homerun cables.
VERIFY POWER IS OFF, then connect cables for
every motor/resolver and preamplifier.
4.11
Appendix A
14
Turn on the equipment.
VERIFY WIRING AND THE VOLTAGE OF ALL
POWER SUPPLIES PRIOR TO POWERING UP.
5.1
15
Input preset data.
Set the preset data for torque, angle, speed, time,
etc.
Chapter 6
Chapter 7
16
Verify normal function.
Confirm normal operation.
5.2