Audiovox GX2401c - Manual (Page 26)

GX2401c I/B version 09050A-1
25 09050A-1
OWNER’S MANUAL#
GX2401c
VER.09050A-1
PAGE:
25
English version
the Ni-Cd battery and recharge as described:
DISCHARGING
1. Unplug the telephone line cord from the GX2401c.
2. Make sure that the adapter is connected.
3. Lift the handset out of the base cradle.
4. Press the TALK button of the handset and start discharging.
Once the symbol LOW appears on the LCD Display, it means that the battery level is
low. Let it fully discharge for 12 hours. Once the Ni-Cd battery is fully discharged, you may
now charge the battery to its full capacity.
CHARGING
1. Make sure the adapter and telephone line cord are connected to the GX2401c .
2. Place the handset on the base cradle. The CHARGE indicator of the base unit will light
steadily.
3. Leave the handset charging on the base for 20 hours continuously to get a maximum
charge.
4. The GX2401c is now ready for regular use. Discharge and charge the Ni-Cd battery
again once you notice a decrease in the useable charge time.
TECHNICAL INFORMATION
This cordless phone uses radio frequencies to allow mobility. There are certain difficulties in
using radio frequencies with a cordless telephone. while these are normal, the following could
affect the operation of your system.
NOISE: Electric pulse noise is present in most homes at one time or another. This noise is
most intense during electrical storms. Certain kinds of electric equipment such as light
dimmers, fluorescent bulbs, motors, and fans also generate noise pulses. Because radio
frequencies are susceptible to these noise pulses, you may occasionally hear them in your
handset. Generally, they are minor annoyances and should not be interpreted as defects in
your system.
RANGE: Because radio frequencies are used, location of the base unit can affect operating
range. Try several locations in your home or business and pick the one that gives you the
clearest signal.
INTERFERENCE: Some electronic devices operate in and/or generate interference near the
operating frequencies of your cordless telephone. while several protection circuits are used to
prevent unwanted signals, there may be periods when these unwanted signals cause
interference. If interference occurs frequently, it can be minimized or eliminated by lowering
the height of your base antenna or by relocating the base unit. You can check for interference
before selecting the final base unit location by plugging in the phone.
TROUBLESHOOTING
A. TELEPHONE UNIT TROUBLESHOOTING TABLE
Symptoms Possible Solution / Cause
No dial tone •
Check that the telephone line cord connectors at both ends
are pushed in firmly until they click.
•
If you had a power failure or had unplugged the base unit,
replace the handset on the base unit for two to five seconds