Darex XT-3000A User Manual
Page 15
13
WARNING: Make sure Split Port Cover
and Eye Shield are in place before
sharpening. (International Models Only)
Power up machine
To turn the machine on, push the top of the
rocker switch. The machine will power up and
the grinding wheels will begin to rotate.
Sharpen
1.
To make sure
the drill clears
the wheel, push
the sharpening
tube all the way
to the left
before inserting
chuck.
2.
Insert the chuck
with the thickest
part of the cam
touching the
swing bearing.
3.
Release sharpening tube very slowly.
4.
With slight
pressure
towards the
grinding wheel,
rotate the
chuck 360
degrees,
several times in
a clockwise
direction. To
achieve an
efficient and
balanced
sharpening on
both cutting
edges, avoid stopping when the drill is in
the grind. Do not reposition your hand in
mid-sharpening, wait until the drill rotates
off the wheel. Continue rotating the chuck
in 360 degree rotations until the grinding
noise is minimized to a near silence.
5.
Before removing the chuck, push the
sharpening tube to the left, remove
chuck. Release sharpening tube slowly.
Drill sharpening