Earthway S25 SPRAY-PRO PUSH SPRAYER - Manual (Page 3)

PAGE 3
For Support for your S25, please contact:
n
ortH
a
meriCa
e
urope
DMMP Limited
T: 0845 643 9776
E: [email protected]
W: www.earthway.co.uk
Muggioli Giardinaggio
T: 0422 96 9990
E: [email protected]
W: www.muggioligiardinaggio.com
Earthway Products, Inc.
P.O. Box 547
1009 Maple Street
Bristol, IN 46507
T: 574-848-7491
T: 800-294-0671
E: [email protected]
W: www.earthway.com
EuroAmerica
T: +31 (035) 5315696
E: [email protected]
W: www.euroamerica.nl
5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period
of 5-years to the end user with the original purchase receipt. If a manufacturing non-conformance is found,
Earthway Products, Inc. at its discretion will repair or replace the part(s) or product at no charge provided the
failure is not the result of incorrect installation, mishandling, misuse, tampering, or normal wear and tear as
determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along with
the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty.
Do not return any product without first receiving authorization from Earthway Products, Inc. To seek remedy
under this warranty, contact Earthway Products, Inc. at 574-848-7491, [email protected] or write to
Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature of the manufacturing defect.
SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges associated
with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most
fertilizers and ice melt products, Earthway Products, Inc. makes no warranty against and specifically excludes
part(s) or product degradation or failure due to corrosion or its effects. Clean and dry your sprayer thoroughly
after each use, as a preventative measure, coat all metal parts (inside and outside of the tubing) with a light oil or
silicon spray.
4
3
2
1
NOZZLE
with
FLAT SIDES
align with
CAP Tabs
RUBBER
WASHER
CAP in ready to
install position
CAP in LOCKED
position
DCV Locking Tabs
CAP Tabs
Nozzle Installation
5
To remove turn Cap from right to left
5
Push Nozzle out of the Cap and remove rubber washer.
5
Install Nozzle aligning the flat sides with the Cap tabs and
reinstall rubber washer.
5
To install the assembly, align the Cap slot with DCV locking
tabs and push onto DCV and turn left to right to lock.