Earthway 2170 Commercial Broadcast Spreader - Manual

32103
Qty 9
32100
Qty 2
33117
Qty 1
36300
Qty 6
12152
Qty 2 12148
Qty 2
33109
Qty 1
36214
Qty 4
36105
Qty 1
33108
Qty 1
36210
Qty 2
31100
Qty 4
31106
Qty 2
31120
Qty 5
vvvvvvvv vvvvvvvv
13
16
17
31
24
28
23
25
26
9
11
12
1. Remove and identify all loose parts from carton .
(Qty 4 #36214)
1/4-20 X 1½”
Phillips Panhead
(Qty 4 #36300)
1/4-20 SS Locknut
2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2” Pan
Head Phillips bolts and (4) 1/4-20 nylon insert locknuts. First put bolts
through holes in frame then through holes in bottom of hopper. Secure
with locknuts. TIGHTEN THESE LOCKNUTS NOW - DO NOT
TIGHTEN WITH POWER TOOLS.
12-2011 Pt# 52164 PAGE 1
2170 C
ommerCial
B
roadCast
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The
impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller
plate after each use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your
spreader thoroughly after each use. Coat all metal surfaces (inside & outside of chassis) with light oil or silicon spray to
help prevent corrosion. Wash between the shut off plate and bottom of the hopper. Do not use powdered materials.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
EV-N-SPRED EV-N-SPRED
EarthWay EarthWay
R R
PLEASE CONTACT US IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY
QUESTIONS REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL
SUPPORT. HOT LINE: 574-848-7491 OR 800-294-0671, EMAIL: [email protected]
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage gearbox and can
void warranty.
Use only granular materials.