Spread path, Full rate, Half rate – Earthway 2170 Commercial Broadcast Spreader User Manual

Page 5

Advertising
background image

PAGE 5

The settings furnished on the Rate Setting Matrix are intended as a guide only. Variations in physical characteristics of

material applied, walking speed, and roughness of ground surface may require slightly different spreader settings. Due to the

above conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from the settings

listed.

HOW TO ORDER SPARE PARTS

All spare parts listed herein may be ordered direct from the manufacturer. Be sure to give the following information when ordering.

;

Model Number

;

Part Number

;

Part Description

You can contact us by calling (574) 848-7491 or 800-294-0671 to place an order with a credit card.

Questions? [email protected]

FULL Rate

(one pass)

HALF Rate

(two passes)

SPREAD PATH

5-YEAR LIMITED WARRANTY

Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-Years to the end user

with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc. at its discretion will repair or

replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering,

or normal wear and tear as determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along

with the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty. Do not return any

product without first receiving authorization from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products,

Inc. at 574-848-7491, [email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe

the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges

associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and ice

melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure due to

corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure, coat all metal parts (inside and

outside of the steel tubing) with a light oil or silicon spray.

OPERATING INSTRUCTIONS

Before filling hopper, become familiar with the operation of this spreader.

5

Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or from our web site

under the MANUALS SECTION.

5

Move stop bolt on rate gauge assembly to the proper setting.

5

While pushing spreader forward, pull control lever back to stop bolt.

5

To stop, push lever forward to close flow holes before you stop moving.

5

When finished, empty any remaining material from hopper.

5

Thoroughly wash spreader and allow to dry before storing. A coating of light oil will help prevent corrosion.

5

If you must use Rock Salt, remove agitator when using Rock Salt to prevent damage to the gearbox.

Advertising