General Pump KT - Manual (Page 22)

GENERAL PUMP
A member of the Interpump Group
KT SERIES
Page 22 Ref 300941 Rev.A
03-14
Conclusion: with a wheelbase of 600 mm an with a dynamometer, loading the belt branch with 75 N as indicated in
fig. 12, a “te” bend of approximately 10.8 mm is obtained.
Note: unless otherwise state by the supplier of he belts, control of proper pull and its relative re-tensioning should be
performed after no less than 30 minutes of motion necessary for the normal adjustment of the belts. Best performance
and durability will be achieved with proper tensioning.
Note2: In case of necessity or for routing maintenance, never replace a single belt but the complete set.