Hauler Racks SERVICE BODY ‘C’ MOUNT RACKS User Manual
Page 14
12. (Continued) Install series 2000 side panels (EX version only)
Starting at the front of the series 2000 panel, drill through the upper hole and through the 2” bracket.
Place a 5/16” bolt through the hole and tighten with a lock washer and nut.
Check to make sure the rear of the series 2000 panel has not moved on the other 2” bracket. Adjust if
needed and re-clamp.
Return to the front of the series 2000 panel and drill the lower hole. Place a bolt through the hole and
tighten with lock washer and nut.
Move to the 5” bracket in the middle. Drill next set of two holes and secure with bolt, lock washer and
nut.
Move to the rear of the series 2000 panel and drill the last two remaining holes and secure with bolt, lock
washer and nut.
Tighten all hardware to secure the series 2000 panel to the rail.
Repeat for other side.
13. Check all rack hardware to make sure all nuts and bolts have been tightened.
HAULER RACKS, INC.
Toll Free: 1-800-843-5445
7109 31
st
Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 14 of 15 WWW.HAULERRACKS.COM