Hauler Racks Universal Steel Truck/Cap Rack (STC3-1) - Manual (Page 13)

13 of 16
HAULER RACKS, INC.
7109 31
st Avenue North
Minneapolis, MN 55427-2848
WWW.HAULERRACKS.COM
Toll Free: 1-800-843-5445
Phone: 763-546-5620
Fax: 763-546-0933
Step 10 Front Leg to front rail
Remove the tape from the front leg rail pass through tubes and adjust the front legs so they are perpendicular to the
rails.
Check that the legs to crossbar assembly is square and tighten the hardware, starting with the crossbar bolts and
then proceeding to the legs.
Locate the center of the holes on the front legs rail pass through tube marked holes and use a center punch
Drill a 3/8” holes on one side and insert a 3/8” bolt through the leg and into the rail to hold the leg to rail assembly in
place and continue to drill the other (3) holes.
Secure with hardware and apply silicone to the flat washers.
Tighten the leg hardware.
Repeat for other side.
Seal the gap of the front rail and the rail pass through tubes with silicone.
Check to make sure the crossbar is square to the upper portion of the legs. Adjust as needed and then tighten the
hardware.
Go around rack and check and tighten all hardware.