LOCKSTATE LS-L500i - Manual (Page 4)

5
Programming Button/Enter Button
Number Buttons
Cylinder
Washer
Battery Lid
Battery Holder
The Programming/Enter Button is utilized for unlocking the door after entering
user codes, clearing errors and programming the lock. It's also a lock button.
Enter User Codes (4-10 digits in length) and program the lock via the number
buttons.
Lock or unlock the latch bolt by key from exterior.
Protects the lock from water damage.
Slide the lid to change the batteries or access reset button.
Uses Four AA (1.5V) Alkaline batteries.
6
Programing Your Lock
1. The default User Code on the lock is 1234
2. The default Programing Code (PC) on the lock is 12345678
3. Please change both of these codes when first setting up the lock for security purposes.
This can either be done through keypad programming
(refer to Keypad Programming Functions section).
IMPORTANT: Before programming anything else on your Deadbolt Lock, you must first
set the handing (whether your lock is on the right or left side of your door).
To do this, follow these steps:
1. Put your lock in the locked position with the deadbolt fully extended by turning the
thumb turn.
Programming your lock can either be done through your online account on the Device
Web Management portal (refer to the Internet Connection Setup Guide) or on the
keypad of the lock. Several of the programming functions that are available online
are not available via Keypad Programming (creating guest codes, schedules, alerts, etc.).
However, common functions such as adding or deleting User Codes can also be done
through Keypad Programming.
For instructions on programming via your keypad, please refer to the Keyad
Programming Functions in the next section.
1.Default Settings
2.Set Lock Handing (Deadbolt Lock Only)
3.Connect Your Lock to the Internet& Login to Device Web Manager
4. Initial Lock Programming
2. Enter the following on the keypad: [Programming Code] + 140 + LockState Button
3. You will see 2 green flashes and hear two beeps if successful
Note: For the lever lock, you do not need to perform this operation.
Your lock has a built in Wi-Fi chip that allows you to program and control your lock from
the internet. Connecting your lock to the internet is required for remote operation and
other advanced features such as temporary guest codes, schedules, rules & alerts.
However, connection to the internet is not required for the lock to operate. In fact,
all programming enabled on the lock will continue to operate if your internet
connection is interrupted.
To connect your lock to the internet via your Wi-Fi router and to login to your online
Device Management account, please refer to the Internet Connection Setup Guide
provided separately with your lock.
Turn-Piece
Retract/Extend the latch bolt from door.