Tools required – Reese 37051 MULTI-FIT RECEIVER User Manual
Page 4
CHEVY EXPRESS and GMC SAVANA
‘
96-06
1. Center the hitch under the frame as far rearward as possible against the end of the frame. Clamp in place.
2. Loosely attach the bolt on brackets as shown. It will bolt in next to the spring hanger. You may need to move the hitch
slightly rearward to give it room next to the spring hanger support.
3. Using the hole in the flange as a guide, drill 1/2
"
holes through the bottom of the frame. Install 1/2
"
bolt through bolt plate
and insert through the frame and install 1/2
"
flat washer, 1/2
"
lock washer, and 1/2
"
nut. You will not be able to use the
existing holes in the frame.
4. Torque 1/2
"
nuts to 70 ft•lb.
‘
92-
‘
03 FORD ECONOLINE and SUPER WAGON,
‘
04-
‘
06 ECONOLINE EXCEPT E-350
1. Attach the hitch to the van using the existing holes at the end of the frame. Insert 1/2
"
x
1
3/4
"
long hex bolts with bolt plates
down through the holes in the frame and the hitch. Install 1/2
"
flat washers, 1/2
"
lock washers, and 1/2
"
nuts.
2. Attach the bolt on brackets (shown) to the hitch as shown in the diagram with 1/2
"
x
1
1/4
"
long hex bolts, 1/2
"
lock washers,
and 1/2
"
nuts. Leave the nuts loose.
3. Insert 1/2
"
x
1
3/4
"
long hex bolts with bolt plates down through the holes in the frame and the hitch. Install 1/2
"
flat washers,
1/2
"
lock washers, and 1/2
"
nuts. Drill 1/2
"
holes in the frame for these bolts if your frame holes don’t line up.
4. Torque 1/2
"
nuts to 70 ft•lb.
1/2
"
X 1-3/4" HEX BOLTS
BOLT PLATE
1/2
"
X 1-1/4" BOLT
1/2
"
LOCK WASHER
1/2
"
NUT
1/2
"
FLAT WASHER
1/2
"
LOCK WASHER
1/2
"
NUT
BOLT ON BRACKET
TOOLS REQUIRED
1/2"
DRILL BIT
3/4"
SOCKET
3/4"
WRENCH
TORQUE WRENCH
SAFETY GLASSES
FLANGE