Reese 33093 PROFESSIONAL RECEIVER User Manual
Installation instructions, Part numbers
Installation Instructions
Chevrolet Silverado Pickup
GMC Sierra Pickup
(Requires OEM Bumper)
Part Numbers:
75362
33093
44564
87186
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4 , 7/8, 21 mm
Drill Bits: None
Frame
1
Fasteners Typical Both Sides of Vehicle
Note: Factory Installed Steel Step Bumper and Brackets Must Be Used In Conjunction with Hitch
1. Remove existing M14 bolts from end of each frame rail.
2. Lift receiver into position, locating rearmost slots in receiver under existing weldnuts in vehicle frame.
3. Reinstall existing M14 bolts through receiver and frame into existing weldnuts.
4. Install remaining fasteners as shown.
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
z 2005, 2006, 2009, 2013 Cequent Performance Products
Sheet 1 of 3
75362N
9-6-13
Rev. G
1
1
1
1
Qty. (4)
Carriage Bolt 1/2-13 X 1-3/4
3
3
3
3
Qty. (4)
Conical Washer 1/2
2
2
2
2
Qty. (4)
Spacer
4
4
4
4
Qty. (4)
Hex Nut 1/2-13
Tighten M14 CL10.9 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75362F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing
8000 (3632 Kg)
800 (363 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg)
600 (272 Kg)
Wiring Access Location: PU3
Form: F205 Rev A 5-6-05
2
3
4
Existing Weldnut Typical both sides
Factory installed Bumper Bracket
- Typical Both Sides
Note: All Fasteners Typical Both Sides of Vehicle
Note: Factory Installed Steel Step Bumper
and Brackets Must Be Used In
Conjunction with Hitch
Existing M14 bolt
Printed in Mexico