Reese 33021 PROFESSIONAL RECEIVER - Manual

INSTALLATION INSTRUCTIONS
Product No.
33021
TOOLS REQUIRED
You can take it with you.
SMALL PARTS
PACKAGE 37336
PLYMOUTH, MI
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
(OVER)
For Installation Assistance or Technical Help, Call 1-574-537-6993
33021IN-20NOV02 PCN6132 © 2002 TOWING PRODUCTS Litho in USA
BLAZER/JIMMY/BRAVADA
EXISTING FLANGE NUT
EXISTING BOLT PLATE
3/4” BOLT
3/4” NUT
3/4” LOCK WASHER
3/4” FLAT WASHER
18mm WRENCH
1 1/8” WRENCH
18mm SOCKET
1 1/8” SOCKET
TORQUE WRENCH
1. Spare tire may need to be loosened for hitch installation.
2. Remove the two forward 12mm nuts that hold the bumper bracket to the frame. These are above the
leaf springs. Remove the bolts. Repeat for the other side. Do not remove the rear two bolts, the bumper
will fall.
3. Lift the receiver up along the outside of the frame and bumper brackets. Insert 3/4” hex head bolts with
flat washers through the holes in the side of the frame. See diagram above. Install 3/4” flat washer, 3/4”
lock washer, and 3/4” nut.
4. Reinstall the factory bolts and nuts through the frame and receiver brackets. See diagram above.
5. Torque the 12mm nuts to 75 ft*lb.
Torque the 3/4” nuts to 200 ft*lb.
6. Retighten the spare tire
98-CURRENT VEHICLES