Reese 44576 PROFESSIONAL RECEIVER - Manual

Installation Instructions
Dodge Sprinter (Van and Cab & Chassis)
Freightliner Sprinter (Van and Cab & Chassis)
Part Numbers:
87441, 75239 UH
75549, 44576
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 19mm
Drill Bits: None
Sprinter Van Models:
1. Remove tie down hook from passenger’s side frame rail and return tie down hook and fasteners to vehicle owner.
2. Raise hitch into position and install fasteners as shown, installing hex bolt and lock washer through round hole in hitch bracket
and hex bolts and toothed washers through oblong slots in hitch bracket, each side.
Sprinter Cab & Chassis Models:
1. If present, remove wheel chock bracket from driver’s side frame rail and retain bracket for reinstallation. Discard bolts.
2. Raise hitch and wheel chock bracket into position and install fasteners as shown, installing hex bolt and lock washer through
round hole in hitch bracket and hex bolts and toothed washers through oblong slots in hitch bracket, each side.
z 2011, 2012 Cequent Performance Products Sheet 1 of 3 75549N 02/24/12 Rev. F
j
Qty. (8) Hex Bolt M12 x 1.75 x 120mm CL8.8
m
Qty. (8) Spacer ¼ x 1 x 2
k
Qty. (6) Toothed Washer ½” n
Qty. (8) Hex Nut M12 x 1.75
l
Qty. (2) Lock Washer ½”
Tighten all M12 x 1.75 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75549F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 7500 (3405 Kg) 750 (341 Kg)
Weight Carrying
Ball Mount
6000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: SUV1, SUV2
Form: F205 Rev A 5-6-05
Vehicle Frame
Vehicle Fascia
Fasteners typical both
Sides of vehicle
Vehicle Frame
jkmn
jlmn
(144” and 170” Wheelbase)
NOTE:
Unconfirmed reports of vehicles with
30-3/8” frame widths, (measured
outside to outside of frame).
This hitch will not fit a vehicle with a
30-3/8” wide frame measured outside
of frame to outside of frame.
Mercedes Sprinter (Van and Cab & Chassis)