Reese 44693 PROFESSIONAL RECEIVER - Manual

1. Lower and remove spare tire from vehicle. The tire release is located inside rear cargo area in middle of floor.
2. Lower exhaust by removing the rear hanger.
3. Lower exhaust by removing the rear and side hangers.
4.Using a 3/4 inch hole saw drill hole on inside frame rail both sides to fishwire bolts into frame.
5. Insert 1/2” bolts and blocks through into the frame as shown in Figure 1.
6. Raise hitch into place over bolts and hand tighten so hitch is held into position but can be moved to line up front holes.
7. Insert 1/2” bolts and blocks into end panel through existing access hole and though existing holes in panel.
8. Trim rear fascia plastic as needed to allow bolts to some though and install washer and nuts.
9. Reinstall exhaust hangers into mounts.
10. Reinstall spare tire and make sure it is seated properly.
Installation Instructions
Nissan NV200
Part Numbers:
75780
44693
87640
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”
Drill Bits: 3/4” HOLE SAW
z 2013 Cequent Performance Products, Inc. Sheet 1 of 3 75780N 5-7-13 Rev. A
1 1 1 1 Qty. (8) CARRIAGE BOLT 1/2-13 X 1.50 4 4 4 4 Qty. (2) BLOCK .250 X 1.50 X 3.00
2 2 2 2 Qty. (8) 1/2” Conical Washer 5 5 5 5 Qty. (6) BLOCK .250 X 1.00 X 3.00
3 3 3 3 Qty. (8) HEX NUT 1/2-13 GRADE 2 6 6 6 6 Qty. (4) PULL WIRE
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75780F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing DO NOT USE WITH SPRING BARS
Weight Carrying
Ball Mount
3500 Lb (1589 Kg) 525 Lb (238 Kg)
Wiring Access Location: SUV1, SUV2
Fascia
Fasteners typical both sides
Frame rail
15
Figure 1
Form: F205 Rev C 9-17-2012
Accessory Rating C
Tighten 1/2”-13 Gr.5 bolts /nuts with torque wrench to 75Lb.-Ft. (102 N*M).
Drilled
holes
23
23
Screw Driver: flathead
14
Leaf Spring
Figure 2
Kink pull wire to keep
Block independent
of bolt