Elite series – Reese 30144 18K ELITE SERIES User Manual
Page 5
If your truck is equipped with a plastic bed liner, then cutting or removal of the plastic bed liner will be
necessary for the proper installation and operation of the
Elite Series
FIFTH WHEEL SLIDER HITCH.
Refer to the “Plastic Bed Liner Instructions” portion on this page for complete instructions on where to cut
your plastic bed liner. If your truck is not equipped with a plastic bed liner or if it has a spray in bed
liner, than you should use the instructions provided in the mounting kit for your specific truck and
skip to page 6 for the rest of the
Elite Series
FIFTH WHEEL SLIDER HITCH assembly
Plastic Bed Liner Instructions:
skip to page 6 for the rest of the
Elite Series
FIFTH WHEEL SLIDER HITCH assembly.
1.
Follow the mounting kit instructions for your specific vehicle.
2.
Measure and mark the distances provided in
Figure 8
for the correct areas to be cut out of your plastic bed
liner.
3.
Remove the plastic bed liner from your truck and cut out the marked areas with a saw or cutting device of
your choice.
4.
Reinstall the plastic bed liner.
5.
Continue the rest of the
Elite Series
FIFTH WHEEL SLIDER HITCH assembly.
Front of Truck
Center of hole
Center of hole
Center of hole
Center of hole
Center of hole
Center of hole
Figure 8
TAILGATE
30144N– 05JUL10A PCN13292 ©2010 CEQUENT PERFORMANCE PRODUCTS, INC.
Litho in USA
5
For Kit 30144
Figure 8
TAILGATE