Reese 30061 RAIL KIT - Manual (Page 6)

6
30061IN – 08-29-08D PCN11348 ©2005, 2008 CEQUENT TOWING PRODUCTS, INC. Litho in USA
7. Insert rails as shown in the following steps ( Figures 9 through 14 ). With flat side up rear rail (short rail) should be
inserted first. With flat side up insert front rail (long rail) second.
Step 1 : Slide the rear rail (shorter length) in
at an angle over the axle. Lift and rotate it
so that it rests on the frame (drivers side)
Step 3 : The rail should now be near the rear hat
channel with both ends resting evenly on the frame
Step 2 : Slide the rail towards the rear
hat channel
F
r
a
m
e
Fuel
Cell
F
r
a
m
e
Front Hat Channel
Rear Hat Channel
Figure 9
Forward
Step 5 : Lift and rotate the rail over the
exhaust and towards the hat channel
Forward
Step 4 : Slide the front rail (longer) in at
an angle over the axle, over the exhaust
and unto the frame (passenger side)
Figure 12
Figure 10
Figure 11
Figure 13