Reese 30061 RAIL KIT User Manual
Page 9
9
30061IN – 08-29-08D
PCN11348
©2005, 2008 CEQUENT TOWING PRODUCTS, INC.
Litho in USA
11.
Remove 5/8” x 1 1/2“ bolts attaching frame bracket to mounting rails. Move rails rearward or forward to prevent
interference with hole drilling or punching of the truck bed.
12.
Drill pilot holes in truck bed at prick mark locations. With hole saw or knockout punch create 2 1/2” hole
centered at pilot holes. Note: Consult installer for recommended curing time on spray-in liner before cutting
holes through bed. Optional: Spray under coating around 2 1/2” holes to prevent rusting.
13.
Loosely reattach rails to frame bracket.
14.
From truck bed attach pucks and trim rings to rails (
Figure 21
) using 5/8” button head screw and lock washer.
Tighten to 100ft.lbs. torque.
15.
Insert puck plugs in plugs whenever pucks are not in use. (
Figure 22
)
16.
Install
Signature Series
5th wheel per hitch assembly instructions.
17.
Torque hitch assembly bolts per hitch instructions.
18.
Torque all 5/8” rail kit hex bolts to 170ft.lbs
19.
Replace any brake lines and spare tire that may have been removed/relocated.
WARNING:
DO NOT lubricate threads. It may cause bolt failure.
CAUTION:
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural
members, etc.
CEQUENT TOWING PRODUCTS
does its best to communicate tow vehicle manufacturer
changes; however, it is ultimately the responsibility of the installer to prevent damage due to installation.
Figure 21
5/8” button head
4 places
Puck
4 places
Trim ring
4 places
5/8” lock washer
4 places
Figure 22
Truck Bed
Puck Plug
Puck Assembly