Reversomatic SA-90S_SA-90SM - Manual (Page 2)

READ AND SAVE THESE INSTRUCTIONS
UNPACKING
Unpack the fan very carefully from the box. Check all components listed in the accessories
are included. If any components are missing, please contact factory or authorized distributor.
SA-150S,
SA-200S models
a)
1
pc. Grille
ACCESSORIES
c)
2
pcs.
Extension
Bracket
b)
2
pcs. Mounting Bracket e)
8
pcs. Sheet Metal
Screws (1 1/4” long)
d)
4
pcs.
Screws (3/8”)
Bracket
Extension
SA-50D,SA-70D
SA-90S models
GENERAL SAFETY INFORMATION
1. Do not install this fan where air temperature may exceed 40 C (104 F).
2. The electric service supply voltage must be 120V/60HZ.
3. Do not kink or excessively bend the electrical wires.
4. Follow all the appropriate codes, i.e. local electrical and safety codes, the National Electrical
Codes (NEC) and the Occupation Safety And Health Act (OSHA) .
5. Always disconnect the electrical wires before working on or near the fan, motor, or junction box
6. Protect the electrical wires from sharp edges, oil, grease, hot surfaces, chemicals, or other
objects.
7. Do not install the unit where ducts where the airflow can be severely restricted.
8. There should always be an adequate air supply to the vented area.
9. This unit is acceptable for use over a bathtub or shower when installed with GFCI protected
branch circuit. The control device should not be installed within reach of the bathtub or shower.
CAUTION
- Do not use in cooking area or kitchens
- This unit must be grounded
- Do not use to exhaust hazardous or explosive materials and vapor
(For General Ventilation Only)
WARNING
1. Use this unit only in the manner intended by the manufacturer. If you have any questions,
contact the manufacturer.
2. Installation work and electrical wiring must be done by qualified person(s) in accordance with
all applicable codes and standards, including fire-rated construction.
3. When cutting or drilling into a wall or ceiling, do not damage electrical wiring and other
hidden utilities.
4. Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the
service disconnecting means can’t be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
2
j.tantay 10.07.09