Robinair 342000 Refrigerant Service Solution - Manual (Page 14)

12
© 1999 Robinair, SPX Corporation
VEHICLES WITH CONTAMINATED SYSTEMS
Before every recovery, the 342000 automatically samples the refrigerant in the
vehicle system. The operator may not bypass this procedure. If a system fails the
purity level required, the 342000 tests a second time. In the event the system fails a
second time, the 342000 prompts you to disconnect the hoses from the vehicle.
Follow the on-screen prompts in order to clear out the 342000.
NOTE: The 342000 must be disconnected from the vehicle before starting the
cleaning process. It is illegal to knowingly vent or allow refrigerant to vent to the
atmosphere. This illegal venting will occur if the machine is left attached to the
vehicle.
Please refer to your shop’s policy for dealing with contaminated refrigerant.
TESTING SOURCE TANKS
Robinair recommends that all source tanks be sampled prior to installation on the
342000. The 342000 does not automatically test the contents of the source tank
prior to adding refrigerant to the internal storage vessel. If a source tank contains
contaminants, these contaminants are transferred to the internal storage vessel.
After a tank fill, the unit samples the contents of the internal storage vessel. When
the internal storage vessel is contaminated, the unit displays:
INTERNAL TANK CONTAMINATION or ID-MALFUNCTION
CONTACT SERVICE
The 342000 locks out all functions until a certified service center decontaminates
the machine. This decontamination is not covered by the warranty.
Set-Up Instructions
After the initial setup is complete, the 342000 will be ready to be powered up.
Use the following steps to power up the 342000:
1. Turn the Main Power Switch ON.
2. The display shows MAIN MENU and SELECT OPERATION when the
unit is ready for operation.
POWER UP