Ronan X11CA Software Manual - Manual (Page 58)

Rev 1.3 Series X11CA Computer Annunciators: X11CA Configuration Software User’s Manual
4. X11CA Software Operation
Hardware Control-© 2003 Ronan Engineering 54
The operational test results depend on the sequence type of each channel. If any
signal is set as inhibition signal for the Global Function keys, it can be tested.
For the sequence process, refer to the sequence charts on the CD.
Functions of the Push Buttons
The following is the summary of the push button functions.
PB Buttons Description
T Test Tests properties of physical alarm modules.
S Silence Stops the sound of the audio devices during the
operational test.
Not available at this time.
A Acknowledge Acknowledges the alarms during the operational
test.
R Reset Resets input to normal during the operational test.
F.R. First Out
Reset Resets the first out alarms during the operational
test.
GF1 General
Function 1 Inhibits the GF1 inhibit signals while the button is
being pressed.
GF2 General
Function 2 Inhibits the GF2 inhibit signals while the button is
being pressed.
Figure 4-38 Push Button Functions