Ronan X96S LEVEL GAGE - Manual (Page 23)

19
Relay Menus
The Relay menus (Relay 1 through Relay 4) are used to configure the X96S relay outputs. These four relay menus show
the settings of the corresponding relay output and allow the characteristics of the output to be changed. Each menu contains the
following items:
ITEM FUNCTION
Source Shows, and allows the user to set, the source
Alarm Type Shows, and allows the user to set, the alarm type
Setpoint Shows, and allows the user to set, the alarm set point
Setpoint2 Shows, and allows the user to set, the second alarm set point 5
Hysterisis Shows, and allows the user to set, the alarm hysterisis percent
Polarity Shows, and allows the user to set, the alarm polarity
Alarm Source is one of the following:
Alarm Source MEANING
Level Operate relay when Level is in alarm as defined the Alarm Type and set points.
HeadTemp Operate relay when the head temperature is in alarm as defined by the Alarm Type and
set points
System Alarm Operate relay when the X96S detects a problem
Detector Flt Operate relay when a there is a problem with detector
Rad Disc Operate relay when the Rad. Disc. function triggers.
Auto Cal Ref Operate relay when the X96S is performing an automatic calibration
Auto Cal Err Operate relay if the X96S detects an error while performing an automatic calibration
Not Used This relay is not currently in use.
Alarm Type is one of the following:
Alarm Type MEANING
None Alarm not yet set
Low Alarm when the source is equal to or lower than Setpoint
High Alarm when the source is equal to or higher than Setpoint
Range Alarm when the source is equal to or lower than Setpoint or equal to or higher
than Setpoint2
Polarity is one of the following:
Polarity MEANING
NO Normally open
NC Normally closed
TTL Menus
The TTL menus (TTL 1 through TTL 4) are used to configure the X96S TTL outputs. These four TTL menus show the settings
of the corresponding TTL output and allow the characteristics of the output to be changed. Each menu contain the following
items:
ITEM FUNCTION
Source Shows, and allows the user to set, the source
Alarm Type Shows, and allows the user to set, the alarm type
5 The second alarm set point is only used when the alarm type is range.