Ronan X96S MASS FLOW GAUGE - Manual (Page 39)

35
Density
This menu contains the following items:
ITEM MEANING
Raw Counts Non-filtered counts from the detector
Raw Density Non-filtered density from the detector
%Density Shows the percent of density based upon the min and max density range
Filt. Counts X96S filtered counts from the detector
Last Ref. Date Shows the date the last reference was performed
Ref Density Shows the actual value of the last density reference performed
Cal Density Shows the actual value of the last density calibration performed
Decay Ref Cap Shows the value of the reference captured counts
Decay Cal Cap Shows the value of the calibration captured counts
Ref Cap Shows the captured counts for the last density reference performed
Cal Cap Shows the captured counts for the last calibration performed
1/uT Shows the calculated slope value (multiplier)
Flow Rate
This menu contains the following items:
ITEM MEANING
Flow Rate Counts Rate of flow (example: feet per second)
% Flow Rate Shows the percent of flow rate based upon the min and max flow rate range
Low Flow Rate Shows the minimum flow rate value
High Flow Rate Shows the maximum flow rate value
Ref.Capt.Value Shows the captured counts for the minimum flow rate referenced
Cal.Capt.Value Shows the captured counts for the maximum flow rate for the last calibration
performance
Pulse Factor Shows the user the Pulse per flow rate (L/s) value
Solids
This menu contains the following items:
ITEM MEANING
Lo Solids Cap Shows the low value solids captured counts
Hi Solids Cap Shows the high value solids captured counts
Solids Counts Shows the current solids counts
Curr. Solids Shows the current solid density value being used for calculating the percent solids.
Min Solids Shows and allows the user to set the minimum solids range
Max Solids Shows and allows the user to set the maximum solids range
Alarms
This menu contains the following items:
ITEM MEANING
Sys. Alarm Shows the status of the system alarm
Det. Fault Shows the status of the detector
AutoCal Ref Shows the status of auto cal reference
AutoCal Error Shows the status of the auto cal error function
Ref. Prompt Prompts the user to complete the next reference
Wipe Test Notifies the user when to conduct the next wipe test (if relay is used)
Shutter Test Notifies the user when to conduct the next shutter test (if relay is used)
Alarms Shows the status of the activated alarm
Dig. Inputs Shows which digital input is in alarm