Salamander Designs Synergy System SLW40C/B - Manual (Page 2)

1
Adapter Plates
2
Install Posts
B. Place the two front posts onto the bracket.
Be sure to square the posts with the shelf.
A. Place a adapter plate at each end of
the base unit. Be sure to align the
bracket with the the holes as shown.
A
A
A
A
B
B
©2005 Salamander Designs Ltd. Doc. #500-960 v 8.05 / 2 of 3
A. Screw threaded studs into the ends
all A posts. Tighten with hex key.
Stick felt pads to underside of post,
this will prevent marring the surface
of the top shelf.
Screw the rear posts through the panel
and into the bottom posts.
Do not over tighten.
- A
- B
Assemble 2 flat nuts with 2 set screws and
slide down the 2 front posts. Place screw
through the hole in the post and tighten.