will be shown within the dialog. Should you decide not to continue with
the upload at any stage, click the Abort button; response to this is usually
immediate, however, during an erase command, the upload will not be
aborted until the erase is complete (this may take a few seconds).

10 - Cycle the power

Disconnect the power. When the power is re-applied the AdderView CATx

1000 will operate using the new firmware.

Issues to consider when performing flash upgrades
The upgrade program rewrites the AdderView CATx 1000 firmware code. If the
upgrade process is interrupted then the AdderView CATx 1000 will have invalid
code and will not be able to operate. It is therefore good practice to ensure
that the upgrade process is always fully completed. A partial or failed upgrade
may be rectified by performing another upgrade. If the upgrade process is
interrupted accidentally then you should press and release the front panel reset
button without re-powering the unit. Running faulty or partially upgraded code
may have unpredictable results and may damage your AdderView CATx 1000 or
computing equipment.
WARNING: Running faulty or partially upgraded code may have unpredictable
results and may damage your AdderView CATx 1000 or computing equipment.

The results of the unit query will be displayed in the Device/Dongle Selection

dialog:

The type and firmware revision of each discovered CAM will be displayed

alongside the port number to which it is connected.

7 - Select the items to be upgraded

Using the Device/Dongle Selection dialog you can determine which items

should receive a firmware upgrade:

• Use the

Program / Verify Main Unit option to include or exclude the

AdderView CATx 1000 unit itself.

• Use the Select All CAMs option to upgrade every discovered CAM.
• Use the Select All USB / PS2 / Sun CAMs options to upgrade only CAMs

of a certain type.

• Use the individual port options to select particular CAM devices to

upgrade.

When the required options have been selected, click OK.
Note: Approximate upgrade times are: AdderView CATx 1000 unit = 4½

minutes; each selected CAM = 20 seconds.

8 - Select the upgrade file to be used

From the main KVM Firmware Uploader dialog, click the Browse... button

and select the upgrade file:

AV1000_x.xx.txt
where x.xx is the firmware version.
The upgrade file details will be displayed within the dialog.
IMPORTANT: Check that the ‘Intended Target Units’ field matches the

‘Unit Connected’ field. If these fields do not match then you may have an
incorrect upgrade file, check with Adder Technology Ltd before proceeding.
Check also that the ‘New firmware version’ is greater than the ‘Current
firmware version’.

Check that the
‘Intended Target
Units’ field
matches the ‘Unit
Connected’ field.

Check also that
the ‘New firmware
version’ is greater
than the ‘Current
firmware version’.

Advertising

Popular Brands

Popular manuals