SecurityMan SolarPIR - Manual (Page 11)

10
Security Code
The SolarPIR comes with a security code that can be use to arm the
alarm motion sensor when away from home and disarm the alarm
motion sensor when entering. The manufacturer default security code
for the alarm motion sensor is 1234.
To change the 4 digit Security Code please do the following:
• Input the factory default security code “1234” (the red LED will start to
flash for 30 seconds indicating that the unit is in programming mode).
• Enter the new 4 digit security code (the red LED will stop flashing
when the new security code is successfully changed and the alarm is
back to disarm mode).
NOTE: The first digit of the new security pass code cannot be the
number 4. Please remember your new password and jot it down.
Mounting SolarPIR™
1. Find and place the alarm in the desired location, preferably facing the
front door or any open area recommended about 5 1/2 – 6 feet from
the ground.
2. Remove and mount the back cover bracket to a desired location as
shown below. Secure the mounting bracket with the
two screws provided.