SecurityMan SolarPIR - Manual (Page 13)

12
Operation
Arming the PIR
To arm the SolarPIR, simply press the number 4 on the keypad. At this
time you will hear a confirmation tone which indicates that the PIR has
been successfully armed.
30-Second exit delay
Once armed, you have 30 seconds to vacate the protected area before
the PIR becomes active. Any motion detected after exit delay time has
expired will trigger the alarm.
5-Second entry delay
When entering the protected area, the user is given 5 seconds after
being detected to disarm the SolarPIR before the siren sounds off.
Disarming the SolarPIR
To disarm the SolarPIR, simply enter in the 4 digit security code. You
will hear a confirmation tone which indicates that the PIR has been
successfully disarmed. Please note that alarm will begin to go off if the
user does not enter the 4 digit security code within the 5 seconds entry
delay time frame.
Alarm sound
The alarm will sound continuously for 30 seconds, then auto reset itself
& continue this process if motion is detected again.
Low battery indicator
The red “Low Battery” LED located at the top center of the unit will light
up whenever the batteries are running low and need to be replaced.