SilverStone CW03 - Manual (Page 15)

16
i MON OEM Touch LCD
H/W and S/W Installation Guide
Dual Monitor Setting for FrontView
In order to use iMON OEM Touch LCD and FrontView application properly, please make setting of your display as like below
before you install the iMON/iMEDIAN software installation.
1. Connect VGA cable of iMON OEM Touch LCD to secondary VGA port on your computer.
2. Set iMON OEM Touch LCD display as your secondary monitor using Extended Desktop.
3. Set screen resolution of secondary monitor as 800*600.
4. Set refresh rate of secondary monitor as 60Hz.
After you finish the dual monitor setting as like above, please install the iMON/iMEDI AN software as below.
iMon / iMEDIAN Software Installation
1.Begin iMON/iMEDIAN software installation by clicking “iMONSetup.exe” and
restart computer.
2.After restarting, iMON Manager will run automatically and launch “iMON
Initial Setup Wizard” window.
3.In”Quick Launch”, select application for Quick Launch button in iMON remote
controller.
4.In “FrontView”, select “Automatically” and finish “iMON Initial Setup Wizard”.