SilverStone DS322 - Manual (Page 4)

1. Introduction
ENGLISH
1.5 Detailed View
1.5.1 LED indication
Note
Note
1.5.2 RAID switch
DIP Switch RAID Mode
Non-RAID
Switch position: 2 ON, 3 ON
Changing the RAID mode requires formatting the drives.
Make sure to backup all existing data first!
RAID 0 - Striping
Switch position: 2 ON, 3 OFF
RAID 1 - Mirroring
Switch position: 2 OFF, 3 OFF
Power
HDD1
HDD2
Non-Raid
Raid 0
Raid 1
Fan
Reset
USB 3.0 port
Power receptacle
Power switch
LED status
Power
HDD1
HDD2
Non-Raid
Raid 0
Raid 1
Red = Power on
Blue = hard drive detected, Flashing=Data access (read/write), OFF=empty drive bay
Blue = hard drive detected, Flashing=Data access (read/write), OFF=empty drive bay
Yellow = Non-raid activated
Yellow = Raid 0 activated
Yellow = Raid 1 activated
In order to determine if the correct mode is selected, please ensure the RAID switch is in the correct position.
Except for the Non-RAID mode, two hard drives are required.
After changing the RAID mode, restart or press the reset button to confirm the new setting.
(The reset button is used to confirm RAID modes and is not to restore to factory settings)
Front View Rear View
RAID switch
3