SilverStone ST75F-G Evolution installation - Manual (Page 5)

Power supply installation (For new system assembly)
Power supply installation (For replacement)
Turn on the power supply by switching to "I" (I/O) mode.
Caution: The power supply is on standby now. System
on and off is controlled by the motherboard.
(Please refer to the motherboard manual)
After turning off the system, switch the
power supply to "O" position to disable
system standby and make sure the system
is no longer drawing any power. Remove all power supply cables
connected to the motherboard, video
card, hard drive and other device.
PSU product manual
ENGLISH
13
1
2
Remove AC power cable from the
power supply. Remove power supply from the chassis.
(Please refer to your chassis's installation manual.)
5. Please refer now to Step 1 of "Power supply
installation (for new system assembly)"
3
4
3