SilverStone ST75F-G Evolution installation - Manual (Page 6)

Power supply usage notes and caution
1. The power supply includes dangerous high voltage; please do not open the power supply in
any condition. Once the power supply enclosure is opened, it will no longer be covered
under warranty.
2. Please use power supply in safe and dry surroundings.
3. Please do not obstruct, insert, or put anything into power supply's vents and any other
openings.
4. The AC cable included with the power supply has been stringently examined by the factory
for defects and quality so please use only the AC cable supplied with your power supply.
AC power cable manufactured by a third party may produce incompatible results and
possibly cause damage to your system or power supply.
5. This product is designed for indoor use only.
Troubleshooting
If your power supply is not operating properly, please refer to the following steps:
1. Please make sure the voltage switch is in the correct mode for use in your location
(115V or 230V). (For power supplies without PFC function only)
2. Please ensure AC power cable is connect to the power supply.
3. Please make sure power supply's "I/O" is switched to "I" mode.
4. Please double check to see if all motherboard, video card(s), hard drives, and devices'
cables are connected correctly.
5. Please turn off the power supply by switching the "I/O" to "O" mode. Wait for approximately
5 minutes for the power supply to reset its protection mechanisms, then switch on "I" mode
and reboot the system.
Caution: The power supply includes dangerous high voltage; please do not open the power
supply under any circumstances. Once the power supply enclosure is opened, it will no longer
be covered under warranty.
PSU product manual
ENGLISH
4