SKC Limited Calibration Adaptor for Cowled Asbestos Sampling Head instructions - Manual (Page 2)

Page 2 007-09-011 Issue B August 2009
SKC Limited 11 Sunrise Park, Higher Shaftesbury Road, Blandford Forum, Dorset DT11 8ST United Kingdom
T: +44 (0) 1258 480188 F: +44 (0) 1258 480184 E: [email protected] W: www.skcltd.com
Use with SKC rotameters
The Calidaptor is screwed into the
top (outlet port) of the rotameter,
tightening enough to just compress
the ‘O’ ring sealing it to the rotameter.
Push the sample head cowl into the
Calidaptor bowl, pressing firmly until
the cowl touches the bottom of the
bowl.
Connect the sample head outlet
hosetail to the pump inlet with a
length of tubing.
Use with other sampling heads
With the Calidaptor fitted to the
top of an SKC rotameter, screw
the supplied hosetail fitting into the
threaded hole inside the Calidaptor
bowl. Connect from the hosetail to
the inlet of the sampling head with a
length of flexible tubing.
Note: If subsequently calibrating an
asbestos sampler ensure that the
hosetail is removed from inside the
Calidaptor bowl.
Use with other types of calibrator
The Calidaptor can be used as
described above, with any other type
of flow calibrator, by screwing the
supplied hosetail into the threaded
hole in the inlet of the Calidaptor.
Connect from the hosetail to the flow
calibrator with a length of flexible
tubing.