Sonic Charge Synplant - Manual (Page 7)

Bottom Sliders
At the bottom of the window you have three additional controllers that are also part of
the patch. Just as with the surrounding controllers, you can click any slider with the
control-key
(Windows) or command-key ⌘ (Mac) held down to reset to its default etc.
Wheel Scaling
This slider controls how much the mod wheel will make the branches grow or in
other words how much it will modulate the sound.
Velocity Sensitivity
Velocity Sensitivity determines how much MIDI velocity affects the patch. On the far
left
(0%) , velocity is ignored entirely. The default setting of 50% should be well-
adjusted for most sounds.
(There is also a global velocity response curve that is not part of the patch. Read the MIDI
Config Dialog section for more information.)
Master Volume
This is the main volume control. Its range goes from infinite negative dB (i.e. entirely
silent) to +20 dB. The normal volume of +/- 0 dB is in the middle. Please observe
that
Synplant
has a built-in saturating limiter and raising the volume excessively will
make it distort. If this happens, the bulb will start to flash with a red light.
Toolbar
Located at the top of the interface is the
Synplant
toolbar. Figure 4 shows the differ-
ent controls on the toolbar. They are described in detail below.
Main Menu
Gene Manipulation Undo
Redo
Patch Selector / Browser
"Modified" indicator
! © 2014 NuEdge Development! 7
Figure 4 Top Toolbar
Figure 3 Bottom Sliders