Sonnet Technologies Fusion D400Q (With Drives) - Manual (Page 5)

Connect Fusion D400Q to a FireWire or USB Port
This section describes the connection of the Fusion D400Q to your
computer’s FireWire or USB ports.
Note: Your Fusion D400Q’s port
layout may be different than what is pictured in this guide
1. Connect the supplied 6" eSATA cable between the SATA out and
SATA in connectors on the back of the enclosure (Figure 6).
2. Connect any one of the supplied USB or FireWire cables between
the appropriate ports on the enclosure and host computer; verify
the connectors are plugged in securely (Figure 7).
Finish Setup
1. Connect the supplied power cable between the Fusion D400Q
and a grounded wall outlet or power strip; verify the cable is
plugged in securely.
2. Push the switch on the back of the enclosure to the on position,
and then power on your computer.
3. Format the drives installed in the Fusion D400Q according to
your needs; refer to your operating system software’s guide or
help section for more information.
Drive Installation and Enclosure Setup
5
Figure 7
Figure 6
FireWire cable (example)
eSATA jumper cable