ID Innovations Bar code Slot Reader - Visible Red and Infra Red - Manual (Page 9)

Features
9
Setup is separated into many different categories ranging from "Interface" to "Cloning". The following is a list of function keys and
the setup category for which they apply:
Key Category Options
F1 Interface Transmit Speed
Keyboard Country
CTRL/Special Char Delay
Send Numerics As
Setup Mode Lockout
Output Mode
Serial Baud Rate
Serial Data Bits
Serial Parity
Serial Duplex
Serial Data Format
Inverted Serial Output
Serial Intercharacter Delay
Serial Caps Lock
Serial Num Lock
F2 Decoders/Scanner Decoders On/Off
Code 39
Code 128
Interleaved 2 of 5
Codabar
Other
F3 Editing Edit #1 - Edit #5
F4 Macros/Special Keys Macro #1 - Macro #5
Keys
F5 Strings String #1 - String #5
F6 Reserved
F7 Buzzer/LED Power Up Beep
Good Read Beep Tone
Beep Duration
No Read LED Delay
LED Power Save Mode
F8 Status/Diagnostics Firmware Version and Release Date
Keyboard Information
Show Scan Codes
F9 Cloning Lockout Cloned Reader Setup Mode
Press ENTER To Begin Cloning
F10 Reset All Defaults Reset All Defaults?
For those categories which have more than one option, the UP and DOWN arrow and ENTER keys are used to move from one
option to the next. In addition to the UP and DOWN arrow keys, the CTRL UP and CTRL DOWN arrow keys are used to move to
the bottom and the top of the list. The following is a list of all special editing keys and a description of their function:
Key Description
Left Arrow, Right Arrow Toggles through the settings for the current option.
Up & Down Arrow
Moves from one option to the previous or next within the category or group.
CTRL Up & Down Arrow Moves to the top or bottom of the category or group.
Home & End
Moves to the beginning or end of an input field.
ALT Backspace Toggles the output mode during configuration, between destructive backspace and
non-destructive backspace. Defaults to non-destructive backspace.
CTRL + Keypad Increases transmit speed during setup.
CTRL - Keypad Decreases transmit speed during setup.
CTRL F7 Test the current Beep Tone and Beep Duration
CTRL F10 Resets the current option to the default setting.
SHIFT F10 If you are in a category with groups (F2-F5), SHIFT F10 resets the current group. If
you are in a category without groups (F1, F7-F10), SHIFT F10 resets the entire
category.
ALT F10 Resets all options in current category to default settings.
CTRL Escape Exit configuration, saving changes (Permanent).
ALT Escape Exit configuration, without saving changes.
Note: If you experience some character loss during setup, you may press the CTRL-(Keypad Minus) key to slow character
transmission. To speed up character transmission, press the CTRL-(Keypad Plus) key.
Note: After 5 minutes of inactivity (no key presses) the decoder will exit setup mode and save all changes.