Inter-M CD-610U - Manual (Page 10)

CD/MP3/WMA/WAV PLAYER
8
CD-610U
Operation Method Operation Method
1. PLAy / PAUSE
1) How to play CD
(1) Insert a disc into the slot, label side upwards.
(2) Select CD mode by pressing the SOURCE button.
If there is no disc, the display will indicate as NO DISC.
(3) After a disc is inserted, the display will indicate the information as below.
- CD-DA : displays total number of tracks and total playback time.
Track : 27 tracks
Total Playback Time: 1hour 19min. 10sec.
- CD-MP3 : displays total number of folders and total number of files.
64 folders / 257 files
(4) Select a track or a file to playback using the select button and the encoder switch.
- CD-DA: select ( I◀◀ ▶▶I) using the SELECT button and select the track to playback by turning the
ENCODER switch.
- MP3
∙ Select using the SELECT button and select the folder by turning the ENCODER switch.
∙ Select (I◀◀ ▶▶I) using the SELECT button and select the track to playback by turning the
ENCODER switch.
(5) Press the button to play.
To skip the track during playback, select ( I◀◀ ▶▶I) using the SELECT button and select the track to
playback by turning the ENCODER switch.
(6) Press the button again to pause. Press the button to stop.
※ Note : 1. A disc which surface status is not good or a disc which format is not compatible cannot be
played and stopped.
2. When a disc format is not compatible, the window displays “NO FILE”.
3. When a disc is inserted upside down, then the window displays “READING ERROR”.
Check the disc status and format because these are not failure of this unit.
2) How to play USB
(1) Insert a USB memory to the USB terminal.