Janam XG105 - Manual (Page 7)

Janam XG Series Quick Start Guide
Getting Started
C. CHARGING THE BATTERY
Important Note: The backup battery, which allows the main battery to be hot-swappable, must charge at a low current.
Initial charge-time for the backup battery, therefore, is 72 hours. This initial charge-time is required prior to first use or
after a full drain of the backup battery. Please see the Product User Guide for additional details.
To charge the battery using the USB Cable or Serial Cable:
1. Connect the power supply to the USB or serial cable.
2. Connect snap-on end of USB or serial cable to syncing/charging connector at the bottom of device (Hardware
Overview #10) making sure the JANAM logo on the connector faces front.
3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that are
easily reached with the length of supplied power cable.
To charge the battery using the Single-Slot or Four-Slot Cradle:
1. Connect the power supply to the cradle.
2. Connect the line cord to the power supply.
3. Insert appropriate AC adapter and plug in the power supply. Use only easily accessible wall outlets that are
easily reached with the length of supplied power cable.
4. Place the device in cradle. The LED will illuminate to confirm connection (orange indicates charging, green
indicates fully charged and red indicates fault).
5. The battery is fully charged in approximately 5 hours.
6. For Single-Slot cradle only: Charge a spare battery by placing the battery in the spare battery well with
connectors lined up. An LED will illuminate to confirm connection.
6