JuiceGoose RX100-RM - Manual (Page 4)

FRONT PANEL
Power On/Off Switch – This lighted rocker switch is located on the left
hand side of the chassis. The switch will light when the RX100-RM is on.
AC Outlets – One unswitched NEMA 5-15R rated for current loads up to
15 amps at 120 volts.
Indicator Lights
Power – This blue light indicates the RX100-RM is connected to mains
power and the ON switch is engaged.
Protection OK – This blue light indicates the RX100-RM protection circuit
is functioning and the main AC power source is correct.
External Fault – In the event of continuous high voltage or incorrect wir-
ing of the line, neutral or ground leads supplying the RX100-RM, the unit
will disconnect equipment plugged into it. The blue Protection OK light
will be OFF and the white External Fault indicator will light.
REAR PANEL
AC Outlets –
Seven NEMA 5-15R outlets (one unswitched) rated for current loads up
to 15 amps at 120 volts.
Breaker
– A resettable, thermal circuit breaker protects the unit from
current overloads. If the breaker trips check for a malfunction in equip-
ment plugged into the RX100-RM. Also check to be certain the total cur-
rent requirement of the equipment plugged into the RX100-RM does not
exceed 15 amps.
The circuit breaker may be reset. Wait 30 seconds after the breaker
trips, turn off the main unit power switch and push the center button on
the breaker back into its original position. Then turn on the main power
switch.
INTERNAL PROTECTION COMPONENTS
The RX100-RM is one of the RX Series products which feature PoweRX
AC power protection. PoweRX protection uses a new, patented Hybrid
AC Filter technology to clean up both Normal Mode and Common Mode
noise without contaminating the ground. Normal Mode noise occurs be-
tween the line and neutral leads of an electric power circuit. Common
Mode noise occurs between either the line or neutral and the safety
ground lead.
UL 1449 limits the amount of current that can pass between line and
safety ground to 0.5 milli amperes. This is called " leakage current". The
Hybrid AC Filter process control board, by using a differential trans-
former and capacitors, acts as a low pass, "line conditioning" filter