JuiceGoose RX100-RM - Manual (Page 5)

which performs in the same way as a series mode inductor. These
components, along with a capacitor between neutral and ground
comprise the foundation of the Hybrid AC Filter design which condi-
tions incoming AC power, removing normal and common mode noise
without adversely affecting the ground line.
TROUBLESHOOTING
The RX100-RM is ruggedly designed and constructed from high qual-
ity components to give years of dependable power for your equip-
ment. It requires neither maintenance nor adjustment. It is unlikely to
malfunction. However, there is one potential event to note:
The RX100-RM will not come on or turns itself off.
a. Check the status of the power supplied to the unit. If line
voltage exceeds 165 volts for 3 seconds protection circuitry will dis-
connect power to the AC power outputs. This will also occur if the
line and neutral leads are reversed. Use a voltage meter and/or po-
larity tester to examine the status of incoming power.
b. Check that the circuit breaker is not tripped and that the
current load on the unit does not exceed its rated 15 amp capacity. If
the breaker is tripped, remove sufficient current load to reduce the
total to no more than 15 amps, wait approximately 30 seconds after
the tripping, turn off the main power switch and push in the circuit
breaker button.
If an observed problem can not be remedied, particularly if the prob-
lem seems severe or dangerous, discontinue use of the RX100-RM
and contact Juice Goose directly.
REPAIR
Should your Rackpower need service contact Juice Goose for assis-
tance and authorization to return the unit. PLEASE NOTE: a return
authorization number is required in order for the service personnel
to correctly and promptly identify, repair and return your unit. You
may obtain a Return Authorization Number by calling: 713-772-1404
or sending email to [email protected].